Measure
A router and ONT together draw relatively little continuous power, but DC output (bypassing the inverter) meaningfully improves runtime versus AC
PORTABLE POWER USE CASE
Adjust the workload, backup duration, conversion efficiency, reserve and surge requirement before comparing products.
✓ 250 W output or higher
✓ 16.7–18.8 hours from an equal-size rated battery
✓ Large / expandable class
✓ Size solar from realistic daily input, not panel nameplate alone
Compare portable power stations →BEFORE YOU COMPARE
A router and ONT together draw relatively little continuous power, but DC output (bypassing the inverter) meaningfully improves runtime versus AC
Check UPS/transfer-switching time if internet continuity during a brief outage matters for your work
Model the total connected-device load (router, ONT, laptop, monitor) together rather than the router alone
A compact-class station can be sufficient for router/ONT alone; add capacity for simultaneous laptop charging
DELTA 2
Its capacity or output is below the conservative default model. Recalculate with measured loads.
RIVER 3 Plus
Its capacity or output is below the conservative default model. Recalculate with measured loads.
C1000
Its capacity or output is below the conservative default model. Recalculate with measured loads.
TECHNICAL AND SAFETY GUIDANCE
LiFePO₄ commonly prioritizes cycle life and thermal stability. Manufacturer cycle claims use controlled conditions.
Panel nameplate watts are not daily energy. Allow for shade, angle, heat, cable loss and controller limits.
Buy the regional output version and confirm appliance voltage, plug shape, frequency and warranty geography.
Passenger limits make nearly every station in this catalogue unsuitable for aircraft carriage.
Transfer time and waveform matter. Do not treat a consumer EPS as medical or zero-transfer infrastructure.
Keep ventilation clear, avoid moisture and damaged cables, and follow manufacturer temperature and grounding instructions.
REMOTE WORK POWER QUESTIONS
No. It is a planning range based on entered watts and efficiency. Temperature, standby draw, power factor and battery controls change real results.